E3D / E3D Revo
Choose the green-sock 0.80 mm Revo version for an installed Revo setup when a larger opening is already part of your print plan. It pairs a wear-resistant construction with a much larger opening than the 0.40 mm version.
Check filament and slicer guidance before switching. Use the supported Revo part and E3D’s care instructions.
E3D identifies this opening with a green sock. The manufacturer also publishes the size table for the other variants.
Keep the 0.40 mm profile for a job that needs smaller extrusion widths. Switch to 0.80 mm only if the print and filament suit the wider profile.
Choose a V6-compatible part for a V6 heater block. This nozzle combines the tip and heat break for the Revo system.
0.40 mm opening
This is a monthly price snapshot supplied by Rainforest, not a live quote. Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com at the time of purchase will apply to the purchase of this product.
0.25 mm opening
This is a monthly price snapshot supplied by Rainforest, not a live quote. Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com at the time of purchase will apply to the purchase of this product.
0.60 mm opening
This is a monthly price snapshot supplied by Rainforest, not a live quote. Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on Amazon.com at the time of purchase will apply to the purchase of this product.
